Brand: GEMMY Industrial | Category: Medical Equipment
A laboratory incubator offered in six capacities from 34 to 150 litres, working from ambient plus 5 degrees C to 75 degrees C, in either an analogue or a digital build. The analogue version uses ON/OFF control with a mercury thermometer on the top of the cabinet and natural gravity convection, giving uniformity of +/-5.0 degrees C and stability of +/-3.0 degrees C at 37 degrees C. The digital version uses microprocessor PID control with forced convection, tightening uniformity to +/-3.0 degrees C and stability to +/-1.0 degrees C at 37 degrees C, and cuts out at 4 degrees C above the set point rather than at 80 degrees C. On the digital model the mechanical 180 minute timer starts only once the set temperature has stabilised, shows END when the cycle finishes, and stores the temperature and elapsed time if the door is opened mid run.
Not sure which configuration you need? Help me choose
Contact Vvon Technologies Limited about GEMMY Industrial equipment requirements in Bangladesh.
Phone: +880 1711-738207 | Email: info@vvon.com.bd
A benchtop universal centrifuge with a stainless steel chamber, adjustable up to 5000 rpm with digital display and a maximum RCF of 4124 x g. Gemmy lists automatic imbalance detection, an electric lid interlock, a 99 minute digital timer and a maximum capacity of 240 ml.
The digital dry bath in the range, with digital setting, an LED digital readout and a digital 99 hour timer, which the analogue DB-005 and DB-006 do not carry. The 450 W heater runs to 99 degrees C with uniformity at 37 degrees C quoted at 0.5 degrees C under PID control, and an over heat alarm is fitted. Net weight is 5.5 kg. The same interchangeable heating blocks accept test tubes, cuvettes and microcentrifuge tubes, each with a well for a removable thermometer, and a solid block turns the unit into a hot plate.
A benchtop universal centrifuge with a moulded stainless steel chamber, analogue speed control and a mechanical timer, running from 0 to 12000 rpm depending on the rotor fitted. Rotors are interchangeable using the supplied hexagon wrench, and a safety locking latch cuts the motor if the lid is opened during a spin.