Brand: EDIBON | Category: Scientific & Laboratory Equipment
An adsorption unit with two activated carbon columns that can be operated in series or in parallel. It reproduces the behaviour of adsorption in physico-chemical water treatment, allowing breakthrough curves and bed exhaustion to be measured under different flow rates.
| Parameter | Value |
|---|---|
| Inner diameter | 60 mm. Height: 700 mm |
| Capacity | 45 l |
| Capacity | 2 l |
| Computer controlled raw water circulation pump, range | 0 - 3 l/min |
| Flow rate sensor to measure raw water, range | 0.25 - 6.5 l/min |
| Electrical supply | single-phase 200 VAC to 240 VAC/50 Hz or 110 VAC to 127 VAC/60 Hz |
Not sure which configuration you need? Help me choose
Contact Vvon Technologies Limited about EDIBON equipment requirements in Bangladesh.
Phone: +880 1711-738207 | Email: info@vvon.com.bd
Back to Scientific & Laboratory Equipment
A continuous flow sedimentation tank for demonstrating the settling of discrete particles. Students measure removal efficiency against overflow rate and detention time and observe the flow pattern through the tank, which underpins primary settlement design.
A membrane unit that performs tangential flow filtration by both reverse osmosis and ultrafiltration. Two variable speed pumps set the feed conditions, so students can measure permeate flux and rejection against pressure, cross flow velocity and feed concentration.
A unit that determines the filterability index of a water sample using a bed of granular material, normally sand, chosen by the student. The measurements taken allow the filterability of different waters and media to be compared before a full filtration design is attempted.